Danfoss VLT AutomationDrive FC 302 Programming Manual page 20

How to Programme
Parameter 1-22 Motor Voltage
2 2
Parameter 1-23 Motor Frequency
Parameter 1-24 Motor Current
Parameter 1-25 Motor Nominal Speed
5-12 Terminal 27 Digital Input
Parameter 1-29 Automatic Motor
Adaptation (AMA)
Parameter 3-02 Minimum Reference
Parameter 3-03 Maximum Reference
Parameter 3-41 Ramp 1 Ramp Up
Time
Parameter 3-42 Ramp 1 Ramp Down
Time
Parameter 3-13 Reference Site
Table 2.3 Quick Set-up Procedure
18
®
VLT AutomationDrive FC 301/302 Programming Guide
OK Set Nameplate voltage
OK Set Nameplate frequency
OK Set Nameplate current
OK Set Nameplate speed in RPM
If terminal default is Coast
inverse it is possible to change
OK this setting to No function. No
connection to terminal 27 is
then needed for running AMA
Set desired AMA function.
OK Enable complete AMA is
recommended
Set the minimum speed of the
OK
motor shaft
Set the maximum speed of the
OK
motor shaft
Set the ramping up time with
reference to synchronous
OK
motor speed, n
Set the ramping down time
with reference to synchronous
OK
motor speed, n
Set the site from where the
OK
reference must work
MG33MI02 - Rev. 2013-11-20
s
s