Parameter Descriptions; Parameter Selection - Danfoss VLT AutomationDrive FC 302 Programming Manual

Parameter Descriptions

3 Parameter Descriptions

3.1 Parameter Selection

Parameters are organised in various parameter groups for
easy selection of correct parameters, for optimised
operation of the frequency converter.
0-** Operation and Display parameters include:
•
Basic Settings, set-up handling
•
Display and Local Control Panel parameters for
selecting readouts, setting up selections and
copying functions
1-** Load and Motor parameters include all load and
motor related parameters.
2-** Brake parameters.
•
DC brake
•
Dynamic brake (Resistor brake)
•
Mechanical brake
•
Overvoltage Control
3-** References and ramping parameters include DigiPot
function.
4-** Limits Warnings; setting of limits and warning
parameters.
5-** Digital inputs and outputs include relay controls.
6-** Analog inputs and outputs.
7-** Controls; setting parameters for speed and process
controls.
8-** Communication and option parameters for setting of
RS-485 and USB port parameters.
9-** Profibus parameters.
10-** DeviceNet and CAN Fieldbus parameters.
12-** Ethernet parameters.
13-** Smart Logic Control parameters.
14-** Special function parameters.
15-** Drive information parameters.
MG33MJ02
Programming Guide
16-** Readout parameters.
17-** Encoder Option parameters.
18-** Readout 2 parameters.
30-** Special Features.
32-** MCO Basic Settings parameters.
33-** MCO Adv. Settings parameters.
34-** MCO Data Readouts.
35-** Sensor Input Option parameters.
NOTICE
To see if a parameter can be used in a specific control
mode, use Table 4.3.
Danfoss A/S © Rev. 10/2014 All rights reserved.
3 3
23