Enabling Transformation Function - Agilent Technologies ENA Series User Manual

Upper limit
The number of response points displayed on the graph is the same as the number of points
regardless of the response resolution.
Operation
Step 1. Press
which you want to set the display range.
Step 2.
Step 3. Press each of the following softkeys and then specify the display range. At the side of the
set value in the data entry bar, the distance corresponding to the set time is displayed
(Figure 8-7). The displayed distance is a value taking the velocity factor into consideration.
Softkey
Start
Stop
Center
Span
NOTE You cannot use hardkeys to set the display. The hardkeys are dedicated to specifying the
sweep range.
Figure 8-7 Data entry bar

Enabling transformation function

Operation
Step 1. Press
which you want to use the transformation type.
Step 2.
Step 3. Press
NOTE The following requirement must be met to enable the transformation function.
• The sweep mode is the linear sweep.
• The measurement points is three or more.
8
*1
T
span
(or
- Press to display the "Transform" menu.
Transform
Function
Sets the start value of the display range in time.
Sets the stop value of the display range in time.
Sets the center value of the display range in time.
Sets the span of the display range in time.
(or
- Press to display the "Transform" menu.
Transform
to enable ( ) the transformation function.
Transform ON
Analysis in Time Domain (Option 010)
Transformation to time domain
) and (or
) and (or
) to activate a trace for
) to activate a trace for
187