Registering The Printer - Agilent Technologies ENA Series User Manual

Data Output
Using a Printer to Output the Screen Image

Registering the printer

From the Print dialog box (refer to Figure 9-10 on page 212), you can select from the
registered printers only. Therefore, when you use the printer for the first time, you need to
register the printer first. When you use a printer supported at the time of shipment with the
parallel port, it is already registered at the factory and therefore you need not to register it
yourself.
NOTE
In the case of the USB port, the ID of the printer is also registered. Therefore, when you
use a printer different from one used for the registration, even if it is of the same model,
you need to register the printer again. When using the parallel port, you need not to register
the printer again as long as you use a printer of the same model.
The registration procedure is as follows:
NOTE You need the mouse and the keyboard for this operation.
Step 1. Restart the E5070A/E5071A in the service mode
i. Press
ii. Press
Figure 9-7 Password dialog box.
iii. Enter the password
iv. Press
Step 2. Connect the printer
Turn on the printer and connect it to the E5070A/E5071A.
Step 3. Move the mouse pointer to the lower left part of the screen of the
click
Step 4. Double-click the Add Printer icon in the Printers window to start Add Printer Wizard.
210
.
Service Menu - Restart Menu
e507xa
. The instrument is restarted and the Windows screen appears.
Restart as Service
- -
Start Settings Printers
. The Password dialog box (Figure 9-7) opens.
in the box and click the
Password
(see the below figure) to open the Printers window.
button.
OK
E5070A/E5071A
and
Chapter 9