Making Measurements
Setting Up the Trigger and Making Measurements
Trigger Modes
Different trigger modes may be set for different channels independently.
Table 5-3
Trigger Modes
Trigger Mode
Hold sweep (
Single sweep (
Continuous sweep
(
Setting Up the Trigger and Making Measurements
1. Selecting a Trigger Source
Follow the procedure below to select a trigger source.
Step 1. Press
Step 2. Press
Step 3. Press the softkey that corresponds to the desired trigger source.
Softkey
Internal
External
Manual
Bus
2. Selecting a Trigger Mode
Follow the procedure below to select a trigger mode.
Step 1. Press
set.
Step 2. Press
124
)
Hold
)
Single
)
Continuous
Trigger Source
(or
.
Function
Disables the sweep. Sending a trigger does not prompt a
sweep.
Executes one complete sweep when a trigger is received.
After completion, the analyzer will be reset to "Hold"
mode.
Executes one complete sweep each time a trigger is
received.
Function
Selects the internal trigger source.
Selects the external trigger source.
Selects the manual trigger source.
Selects the bus trigger source.
) to select a channel for which the trigger mode will be
Chapter 5