Procedure - Agilent Technologies ENA Series User Manual

Procedure

Selecting Contents
Follow the procedure below to save internal data from the E5070A/E5071A.
NOTE
This setting takes the effect both when saving the entire instrument state into a file and
when saving the instrument state for each channel into memory.
Step 1. Press
Step 2. Press
Step 3. Press the softkey corresponding to contents you wish to save or recall.
Softkey
State Only
State & Cal
State & Trace
All
Saving Instrument State
Follow the procedure below to save internal data from the E5070A/E5071A.
Step 1. Press
Step 2. Press
Step 3. When you want to use a pre-defined file name (State01.sta - State08.sta,
Autorec.sta)
Press
NOTE If "A:\Autorec.sta" or "D:\Autorec.sta" is found on the system at startup, the
E5070A/E5071A is automatically configured using the saved settings. When both files are
found, "A:\Autorec.sta" is recalled. To disable the auto recall function, delete the
Autorec.sta files.
NOTE When the files already exist, the * symbol is displayed to the right of their softkey label. If
you specify one of them, the existing file is copied as "backup.sta" and then it is
overwritten.
When you want to use other file name or a file name on the floppy disk
1. Press
dialog box.
2. Select the folder and input a file name using the external keyboard and mouse.
3. Click
Chapter 9
.
.
Save Type
Function
Selects E5070A/E5071A settings only.
Selects E5070A/E5071A settings and calibration data.
Selects E5070A/E5071A settings and traces.
Selects E5070A/E5071A settings, calibration data, and traces.
.
.
Save State
- or
State01 State08 Autorec
to open the Save As dialog box. Figure 9-1 explains the Save As
File Dialog...
Save
Saving and Recalling Instrument State
.
Data Output
197