Procedure - Agilent Technologies ENA Series User Manual

Procedure

Figure 4-15 Connecting the Standard at Full 3-Port Calibration
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. Select the test ports on which a full 3-port calibration will be performed.
Softkey
1-2-3
1-2-4
1-3-4
2-3-4
NOTE In the procedure below, the selected test ports are denoted as x, y, and z.
Step 6. Press
Step 7. Connect an OPEN calibration standard to test port x (the connector to which the DUT will
be connected) selected in Step 5.
Chapter 4
.
.
Calibrate
.
3-Port Cal
.
Select Ports
Function
Selects test ports 1, 2, and 3.
Selects test ports 1, 2, and 4.
Selects test ports 1, 3, and 4.
Selects test ports 2, 3, and 4.
.
Reflection
Calibration
Full 3-Port Calibration
97