Agilent Technologies ENA Series User Manual page 100

Calibration
1-Port Calibration (Reflection Test)
Step 1. Press
Step 2. Press
Step 3. Press
Step 4. Press
Step 5. Select a test port (and corresponding S parameter) on which a 1-port calibration will be
performed.
Softkey
1
2
3
4
Step 6. Connect an OPEN calibration standard to the test port (connector to which the DUT will be
connected) selected in Step 5.
Step 7. Press
Step 8. Connect a SHORT calibration standard to the test port (connector to which the DUT will be
connected) selected in Step 5.
Step 9. Press
Step 10. Connect a LOAD calibration standard to the test port (connector to which the DUT will be
connected) selected in Step 5.
Step 11. Press
Step 12. Press
coefficients will be calculated and saved. The error correction function will also be
automatically enabled.
NOTE By pressing
calibration coefficients. To cancel the calibration without saving the new calibration
coefficients, press
92
.
.
Calibrate
.
1-Port Cal
.
Select Port
Function
Selects port 1.
Selects port 2.
Selects port 3.
Selects port 4.
to start the calibration measurement.
Open
to start the calibration measurement.
Short
to start the calibration measurement.
Load
to terminate the 1-port calibration process. Upon pressing the key, calibration
Done
, previously saved calibration coefficients will be overwritten with new
Done
Cancel - OK
successively.
Chapter 4