Turning The Limit Test On/Off; Initializing The Limit Table; Outputting The Test Result - Agilent Technologies ENA Series User Manual

Limit Test
Limit Test

Turning the Limit Test ON/OFF

You can set the limit test ON/OFF for each trace individually.
Setting the Limit Test ON/OFF
The following steps describe how to set the limit test ON/OFF.
Step 1. Press
will be used.
Step 2. Press or
used.
Step 3. Press to display the Analysis menu.
Step 4. Press to display the Limit Test menu.
Limit Test
Softkey
Limit Test
Limit Line
Edit Limit Line
*1.To use the limit test function, you must first define the limit line. For more on how to
define the limit line, see "Defining the Limit Line" on page 220.
Step 5. Press to turn the limit test ON. To display the limit line on the screen, press
Limit Test
.
Limit Line

Initializing the Limit Table

The following operations initialize the limit table.
• At power-on
• When presetting
• When calling a limit table with zero segments
• When
Clear Limit Table

Outputting the Test Result

The test result is displayed on the screen as a pass or fail. At the same time, the following
methods are ways you can learn whether or not the limit test failed.
• A point that is outside the limit line (that failed the limit test) is displayed in red on the
screen.
• You can make a beep sound.
• The result is provided in the register. (For more information, refer to the Programmer's
Guide.)
• Turning the
ON
224
or to activate the channel on which the limit test function
to activate the trace on which the limit test function will be
- is pressed in the Edit Limit Line menu
OK
- -
Limit Test Fail Sign
Function
Sets the limit test ON/OFF.
Sets the limit line display ON/OFF.
Opens the limit table for editing the limit
*1
line.
in the Limit Test menu will bring up a
Chapter 10