Agilent Technologies ENA Series User Manual page 207

Recalling Instrument State
Follow the procedure below to recall internal data from the E5070A/E5071A.
Step 1. Press
Step 2. Press
Step 3. When you want to recall State01.sta - State08.sta, Autorec.sta
Press
When you want to recall other files
1. Press
box
2. Select the folder and the file using the external keyboard and mouse.
3. Click
Figure 9-2 Open Dialog Box
NOTE
Do not press the disk eject button while the floppy disk access lamp is on. Trying to
forcefully pull the floppy disk out while the lamp is on may damage the floppy disk or disk
drive.
NOTE
When a user file is used in "Extending the Calibration Plane Using Network
De-embedding" on page 153, "Determining Characteristics After Adding a Matching
Circuit" on page 155, or "Determining the Characteristics that Result from Adding a
Matching Circuit to a Differential Port" on page 167 and the setup status is saved, the recall
error will occur if the user file is not located in the previous folder when the state is saved.
Chapter 9
.
.
Recall State
- or
State01 State08 Autorec
to open the Open dialog box. Figure 9-2 describes the Open dialog
File Dialog...
.
Open
Saving and Recalling Instrument State
.
Data Output
199