Procedure - Agilent Technologies ENA Series User Manual

Procedure

Creating a Segment Table
Step 1. Press
segment table.
Step 2. Press
Step 3. Press
The segment table appears in the lower part of the screen.
Step 4. To change the frequency range setting mode or to set the IF bandwidth, power level, sweep
delay time, sweep mode, and sweep time for each segment, use the following softkeys.
NOTE When setting the segment table using the front panel keys or keyboard, you need to place
focus on (select) the operation target (segment table of softkey) first. You can change the
focus by pressing
table, the selected cell is enclosed with the thick line box. When the focus is placed on the
softkey menu, the softkey menu title area is displayed in blue.
Softkey
Freq Mode
List IFBW
List Power
List Delay
List Sweep Mode
List Time
Chapter 11
Performing a Segment-by-Segment Sweep (Segment Sweep)
or
.
.
Edit Segment Table
in the ENTRY block. When the focus is placed on the segment
Function
Switches the frequency range setting mode (start/stop or center/span).
Toggles ON/OFF the IF bandwidth setting for each segment. Only when this
setting is ON, the row (
Toggles ON/OFF the power level setting for each segment. Only when this
setting is ON, the row (
Toggles ON/OFF the sweep delay time setting for each segment. Only when
this setting is ON, the row (
Toggles ON/OFF the sweep mode setting for each segment. Only when this
setting is ON, the row (
table.
Toggles ON/OFF the sweep time setting for each segment. Only when this
setting is ON, the row (
Optimizing Measurements
to select the channel for which you want to create the
) for setting appears in the segment table.
IFBW
) for setting appears in the segment table.
Power
) for setting appears in the segment table.
Delay
) for setting appears in the segment
Sweep Mode
) for setting appears in the segment table.
Time
241