Improving The Measurement Throughput; Using Fast Sweep Modes - Agilent Technologies ENA Series User Manual

Improving the Measurement Throughput

This section explains the following two methods to improve the measurement throughput.
• "Using Fast Sweep Modes" on page 235
• "Turning Off the Updating of Information Displayed on the LCD Screen" on page 236

Using Fast Sweep Modes

There are 4 sweep modes. "Steppd mode" and "swept mode." And, "fast stepped mode"
and "fast swept mode" that are the speeded-up versions of them realized by shortening wait
time during sweep and so on.
Figure 11-5 Sweep Mode
Operational procedure
Step 1. Press
Step 2. Press
Step 3. Press the softkey corresponding to a proper sweep mode.
Softkey
Std Stepped
Std Swept
Fast Stepped
Fast Swept
Chapter 11
.
.
Sweep Mode
Function
Selects the stepped mode.
Selects the swept mode.
Selects the fast stepped mode.
Selects the fast swept mode.
Optimizing Measurements
Improving the Measurement Throughput
235