Stimulus Settings; Setting Sweep Type; Setting The Frequency Range - Agilent Technologies ENA Series User Manual

Stimulus Settings

Setting sweep type

The procedure to select the sweep type is as follows:
Step 1. Press
number of points.
Step 2. Press
Step 3. Press
Step 4. Press the desired softkey to select the sweep type.
Softkey
Lin Freq
Log Freq
Segment

Setting the Frequency Range

The E5070A and E5071A each allow the user to set the sweep frequency range from 300
kHz to 3 GHz and from 300 kHz to 8.5 GHz, respectively. The smallest unit of increment is
1 Hz in all frequency ranges. There are two ways to set the frequency range: by specifying
the lowest and the highest values and by specifying the center value and a span. Once the
frequency range is set, it is possible to change the range by substituting the lowest
frequency, the highest frequency, or the center frequency with a value (stimulus value)
represented by a marker on the trace. The frequency range is set independently for each
channel.
Figure 3-4 Setting the Frequency Range
Chapter 3
or
.
.
Sweep Type
Function
Selects the linear sweep.
Selects the logarithmic sweep.
Selects the linear sweep.
For information on how to use the segment sweep, refer to "Performing a
Segment-by-Segment Sweep (Segment Sweep)" on page 237.
Setting Measurement Conditions
to select the channel for which you want to set the
Stimulus Settings
59