GE
D
5308917-100, R
IRECTION
8-6-1
Flex Cable (MST to TX) Assy (FRU No.5315109)
This is a description on how to remove and replace the TX Board or Flex cable.
8-6-1-1
Tools
Common Phillips screwdrivers
•
8-6-1-2
Needed Manpower
•
1 person, 30 minutes
8-6-1-3
Preparations
•
Shutdown the system and switch off the main Circuit Breaker at the bottom rear side of the system.
8-6-1-4
Removal Procedure
1) Remove the connector board assembly. Refer
2) Loosen the Five screws (1,2,3,4,5,) of TX board from the system. Refer
3) Remove the Tx board from the system. Refer
3) Pull the Tx board from the system.as shown below
4) Remove the Tx conn board cable. Refer
PROPRIETARY TO GE
8
EVISION
1
2
3
Figure 8-80 TX board Assembly
Chapter 8 Replacement Procedures
section 8-5-5 on page 64
Figure 8-76 on page 8-68
4
5
Figure 8-77 on page 8-70
Figure 8-78 on page 8-71
LOGIQ P3 S
M
ERVICE
ANUAL
Figure 8-76 on page 8-68
8-73