P/N: 5262796 - P3, 5455710 - P3Bt); Tools; Needed Manpower; Preparations - GE LOGIQ P3 PRO Service Manual

GE
D 5308917-100, R
IRECTION
8-3-2 Keyboard Knob Set (FRU P/N: 5315502 - P3, 5443870 - P3 BT) & Encoder set
(FRU P/N: 5262796 - P3, 5455710 - P3BT)
This is a description on how to remove and replace the Keyboard knob set Assembly.

Tools

8-3-2-1
• Common Torx screwdrivers
NOTE: B Mode Gain Knob Encoder is not a FRU.
8-3-2-2

Needed Manpower

• 1 person, 15 minutes
8-3-2-3

Preparations

• Shutdown the system and switch off the main Circuit Breaker at the bottom rear side of the system.
8-3-2-4

Removal procedure

1) Pull the knobs out with hands by slightly pushing it up from the bottom edge.Refer
page 8-31
TGC Knob
8-3-2-5 Mounting procedure
1.) Install the new parts in the reverse order of removal.
8-3-2-6 Functional Checkout Procedure
Functional Test
Do Visual Inspection and ensure
no scratches observed and
fitment is done properly
PROPRIETARY TO GE
8
EVISION
Figure 8-33 Keyboard knob set
Service Manual Direction 5308917-100, Section 8-3-3. Equipment passes all required
Chapter 8 Replacement Procedures
LOGIQ P3 S
Encoder knob
Depth Knob
Debrief Script
tests and is ready for use.
M
ERVICE ANUAL
Figure 8-33 on
8-31