Turn On The System; Power Off/ Shutdown; Back-End Processor Power Down - Logiq P3 - GE LOGIQ P3 PRO Service Manual

Table of Contents

Advertisement

GE
D
5308917-100, R
IRECTION
3-5-1-2

Turn on the system

Press the Power On/Off switch at the front of the system once.
When the Power On/Off switch on the Control Panel is pressed once, the TMST starts and the software
code is distributed to initiate the scanner.
No status messages are displayed during this process.
3-5-2

Power Off/ Shutdown

NOTE:
After turning off a system, wait at least twenty seconds before turning it on again. The system may not
be able to boot if power is recycled too quickly.
3-5-2-1

Back-end Processor Power Down - LOGIQ P3

To power down the system:
1.) Press the Power On/Off switch at the front of the system.
2.) The System-Exit window is displayed.
3.) Using the Trackball or Select key, select Shutdown.
4.) The shutdown process takes a few seconds and is complete when the power status LED is turned
Amber color.
5.) Disconnect the probes.Clean or disinfect all probes as necessary. Store them in their shipping
cases to avoid damage.
PROPRIETARY TO GE
8
EVISION
Power On/Off switch
Figure 3-8 Power On/Off Switch
Figure 3-9 System Exit Window
Chapter 3 Installation
LOGIQ P3 S
M
ERVICE
ANUAL
3-11

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LOGIQ P3 PRO and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Logiq p3 bt10Logiq p3Logiq p3 expertLogiq p3 vet

Table of Contents

Save PDF