Battery Removal Procedure; Battery Installation Procedure - GE Venue Fit Technical Publication

P R E L I M I N A R Y
DIRECTION 5854713-100, REVISION 2
8-2-2-4

Battery Removal Procedure

1) Slide down the battery locking latch. While holding the latch down, using your thumb slide the cover
to the right.
2) Remove the battery by sliding it to the right.
8-2-2-5

Battery Installation Procedure

1.) Slide in the battery into the system.
2.) Slide back the battery cover.
3.) Switch On the battery power switch.
4.) Close the battery power switch silicon cover.
Perform the checks listed in
8-4
Figure 8-31 Battery cover removal
Figure 8-32 Battery removal
Table 8-36 - System Parts section
Chapter 8 - Replacement Procedures
VENUE FIT™ SERVICE MANUAL