Connector Board - GE LOGIQ P3 PRO Service Manual

GE
D 5308917-100, R
IRECTION
5-2-5

Connector Board

• There are 3 banks of relays on the Connector Board one each for each probe connector.
• There is one FPGA that acts like a buffer for the Probe related signals and is the interface between
the probe and the main TX Board FPGA. There is a I2C slave also implemented on this FPGA that
responds and interfaces with the Host I2C controller on the TX board it is mainly for probe selection
and control
• The Power supply to the TX board from the PDB board is connected via the Connector Board.
PROPRIETARY TO GE
8
EVISION
Figure 5-13 Connector Board Block Diagram
Chapter 5 Components and Functions (Theory)
LOGIQ P3 S M
ERVICE ANUAL
5-17