Table of Contents
Advertisement
Setting parameter values
You can change a currently displayed parameter in either of the following
ways.
• Turn the one of the four control knobs corresponding to the parameter.
• Press the KEY PAD (1 to 4) button corresponding to the parameter, then
enter the new value using the numeric keypad section.
The following is a concrete example showing adjustment using the control
knobs, as a typical case.
4
Adjust the parameters.
When you have selected a box:
Knob
1
2
3
4
1
Changing the parameter group
When more than one parameter group is shown, to display the parameters in
a different group, press the corresponding function key or the cursor ? or
/ button. Again, when there are five or more parameters in the same group,
as shown in the example above, to display different parameters, press the
cursor > or . button.
In the example, when the parameters "Top", "Left", "Right", and "Bottom"
are displayed, press the > or . button to change to the "Softness" parameter.
You can then adjust the edge softness with control knob 1.
The arrows in icons appearing on the menu screen, as shown below, indicate
which cursor buttons can be used.
In the example below, the vertical arrows indicate that the cursor > and .
buttons toggle between the 1/2 and 2/2 selections. The horizontal arrows
indicate that the cursor ? and / buttons switch to other parameter groups.
Parameter
Setting
Top
Top edge position (0.00 to 100.00)
Left
Left edge position (0.00 to 100.00)
Right
Right edge position (0.00 to 100.00)
Bottom
Bottom edge position (0.00 to 100.00)
Softness
Set the degree of edge softness (0.00 to 100.00)
Example of parameter settings
DROP BORDER (
)
/
1
2
Chapter 3 Basic Menu Operations
3-9
Advertisement
Table of Contents
