Table of Contents
Advertisement
2
Press F1 (DEVICE SELECT) to move the cursor and select the switcher
(SWER) or DMK-7000 (DMK) as the device to which the settings apply.
The menu display changes according to the selection you make.
3
Press F2 (PORT SELECT) or turn control knob 2 to move the cursor and
select the required GPI output port of the device selected in step 2.
4
Press F3 (TRIGGER TYPE), and select the trigger polarity.
Pressing F3 cycles the setting through
If you selected TALLY, continue to step 6.
5
Press F4 (PULSE WIDTH), then turn control knob 4 to adjust the output
pulse width.
6
Press F8 (ACTION SELECT) or turn control knob to move the cursor
and select the action causing the GPI output.
7
Press F6 (SELECT) to confirm the selection of the action causing the
GPI output.
The action you have selected appears in the row for the output port
selected in step 3.
8
To make settings for more than one GPI output port, repeat steps 3 to 7
for each GPI output port.
9
To test the operation of a trigger, press F10 (TEST FIRE).
This outputs a trigger from the GPI output port selected in step 3.
,
,
, NOP, and TALLY.
Chapter 13 Setup
13-61
Advertisement
Table of Contents
