Sony DVS-7300 System User Manual page 382

2
Carry out the operation in the following table to make the required
setting.
Setting
Selecting the system
configuration
Selecting the DMK-7000
configuration
Setting the switcher
program output
Setting the final M/E bank
controlled through the
PANEL 2 connector of the
switcher
Adjusting the switcher
output signal phase
Adjusting the DMK-7000
output signal phase
Multiple cross-point
assignment
You may press F6 and F7 together to adjust the switcher and DMK-7000
output signal phases simultaneously.
Assigning a cross-point assignment table to a port
You can assign any of the five cross-point assignment tables to each of the
9-pin ports on the rear panel. By default table 1 is assigned to all of the
9-pin ports. Use the following procedure.
1
In the SYSTEM CONFIGURATION menu, press F10 (MLT XPT
ASSIGN).
The MULTI XPT ASSIGN menu appears.
PORT
SELECT SELECT
#2
F1 F2 F3
Function key indications in the MULTI XPT ASSIGN menu
Operation
Press F2 (SYSTEM CONFIG).
This toggles the setting between SEPA and PAIR.
Press F3 (DMK CONFIG).
This cycles the setting through CASCAD, PARA,
INDPND and DUAL.
Press F4 (SWER PGM).
This cycles the setting through M/E-1, M/E-2 and
M/E-3.
Press F5 (REMOTE PANEL PGM).
Pressing this button cycles through M/E-1, M/E-2,
M/E-3 and P/P.
Press F6 (SWER), turning it to reverse video, and
adjust control knob 4.
Press F7 (DMK), turning it to reverse video, and
adjust control knob 4.
Press F10 (MLT XPT ASSIGN) to display the MULTI
XPT ASSIGN menu. For details see the next section.
XPT ASSIGN SETUP
TABLE
SELECT 1 2
#3
F4 F5 F6 F7
3 4 5
F8 F9 F10
(Continued)
13-11
Chapter 13 Setup