Table of Contents
Advertisement
Setup Relating to Input/Output Signals (INPUT/OUTPUT Menu)
3
Indications in the SWITCHER INPUT menu
NO: cross-point button number
NAME: signal name
TYPE: input signal type
BITS: number of digital input signal data bits (8 or 10)
GENLOCK: GEN LOCK mode for analog input (AUTO, SYNC or REF)
HUE: hue adjustment value for an analog signal
SCH: subcarrier-to-horizontal phase state
PHASE ADJUST: input signal phase adjustment value
VIDEO SHIFT: indication of whether the input signal has been shifted
13-22
Chapter 13 Setup
Carry out the operation in the following table to make the required
setting.
Setting
Selecting 8- or 10-bit mode
for a digital input signal
Selecting the GEN LOCK
mode for an analog input
signal
Adjusting the hue of an
analog input signal
Adjusting the SCH phase of
an analog input signal
Adjusting the horizontal
phase of an input signal
Selecting automatic color
framing correction by video
shifting
DIG: digital
COL: analog color
MONO: analog monochrome
": phase lagging
p: phase correct
": phase leading
horizontally by the video shifting function.
NORM: not shifted
SHIFT: shifted
Operation
Press F3 (BITS).
This toggles the setting between 8 bits and 10 bits.
Press F4 (GEN LOCK).
This cycles the setting through AUTO, SYNC and
REF.
Press F5 (HUE ADJUST), turning it to reverse
video, and adjust control knob 4.
Press F6 (SCH ADJUST), turning it to reverse
video, and adjust control knob 4 so that the SCH
indication is a black square (p).
Press F7 (PHASE ADJUST), turning it to reverse
video, and adjust control knob 4.
Press F9 (VIDEO SHIFT).
This toggles the setting between ENBL (automatic
color framing correction enabled) and DSBL
(automatic color framing correction disabled).
Advertisement
Table of Contents
