Table of Contents
Advertisement
Carrying out setup relating to through mode (THROUGH MODE
menu)
You can use the THROUGH MODE menu for the following settings relating
to through mode (the mode in which sync signals included in output signals
are passed through unchanged, instead of being replaced by an internally
generated sync signal).
• Input through mode setting: Set the input through mode on or off.
• Output through mode setting: Set the output through mode on or off.
Notes
• The sync signal in the input signal is passed through on the output signal
only if the input through mode and the output through mode are both on.
• The through mode function does not apply to internally generated sync
signals.
To carry out these settings, use the following procedure.
1
In the INPUT/OUTPUT menu, press F8 (THRU MODE).
The THROUGH MODE menu appears.
F1
2
Select the cross-point button to which the input through mode setting
applies, using either of the following methods:
• Hold down F3 (BUTTON No.) and press the required cross-point
button in the auxiliary bus bank.
• Hold down F3 (BUTTON No.) and use the cursor movement keys to
select the required cross-point button.
• Hold down F3(BUTTON No.) and turn control knob 2.
• Hold down F3(BUTTON No.) and enter the required cross-point button
number using the numeric keypad.
BUTTON
INPUT
No.
THROUGH
OFF
F2
F3
F4
F5
Function key indications in the THROUGH MODE menu
BUS
OUTPUT
SELECT
THROUGH
#3
OFF
F6
F7
F8
F9
(Continued)
Chapter 13 Setup
F10
13-33
Advertisement
Table of Contents
