Sony DVS-7300 System User Manual page 400

• Adjusting the vertical blanking interval: Adjust the vertical blanking
interval in the range 10H to 20H (lines) (525-line systems) or 13H to
25H (lines) (625-line systems).
Depending on the output signal selection, the vertical blanking interval
setting applies to the signals from the following three groups of
connectors:
• PGM OUTPUTS, PST OUTPUT, ME-1 OUTPUT, ME-2 OUTPUT,
ME-3 OUTPUT, CLEAN OUTPUT
• EDIT PVW OUTPUT
• AUX BUS OUTPUT 1 to AUX BUS OUTPUT 13
Thus, for example, selecting M/E-1 OUTPUT as the output signal
applies the same vertical blanking interval setting to all members of the
group (PGM OUTPUTS, PST OUTPUT, ME-2 OUTPUT, ME-3
OUTPUT, and CLEAN OUTPUT).
• Selecting the bit rounding function for 10- to 8-bit conversion (D2
systems only): Set the bit rounding function on or off.
• Selecting the bit rounding function for luminance signal 10- to 8-bit
conversion (D1 systems only): Set the luminance signal bit rounding
function on or off.
• Selecting the bit rounding function for chrominance signal 10- to 8-bit
conversion (D1 systems only): Set the chrominance signal bit rounding
function on or off.
To carry out these settings, use the following procedure.
1
In the INPUT/OUTPUT menu, press F6 (SWER OUTPUT).
The SWITCHER OUTPUT menu appears.
OUTPUT
ADJUST1
F1 F2 F3
Function key indications in the SWITCHER OUTPUT menu
OUTPUT
ADJUST2
F4 F5 F6 F7 F8 F9 F10
(Continued)
13-29
Chapter 13 Setup