Sony DVS-7300 System User Manual page 403

Setup Relating to Input/Output Signals (INPUT/OUTPUT Menu)
Carrying out setup relating to DMK-7000 output signals (DMK
OUTPUT menu)
You can use the two menu screens accessible from the DMK OUTPUT menu
for the following settings.
Settings in screen 1
You can make the same settings as in screen 1 of the SWITCHER OUTPUT
menu (see page 13-28) relating to the DMK-7000 output signals.
Settings in screen 2
You can make the same settings as in screen 2 of the SWITCHER OUTPUT
menu (see page 13-28) relating to the DMK-7000 output signals.
Note, however, there are the following differences between the two menus.
• Setting to determine use of a switcher output for input to the DMK-7000
• In the DMK OUTPUT menu, you can set the vertical blanking interval for
To carry out the settings using the DMK OUTPUT menu, proceed as follows.
1
2
13-32
Chapter 13 Setup
does not apply to the DMK OUTPUT menu.
each output signal individually.
In the INPUT/OUTPUT menu, press F7 (DMK OUTPUT).
The DMK OUTPUT menu appears.
OUTPUT
ADJUST1
F1 F2 F3
Function key indications in the DMK OUTPUT menu
Carry out the operation in the same way as for steps 2 and 3 of the
operating procedure under the section "Carrying out setup relating to
switcher output signals (SWITCHER OUTPUT menu)" (see page 13-
30).
Output signals selectable for the settings made in screen 2
DSK1 to DSK4 PROGRAM OUTPUTS,
DSK1 to DSK4 PREVIEW/KEY OUTPUT, CLEAN OUT,
DME-I/F VIDEO OUTPUT, DME-I/F KEY OUTPUT
OUTPUT
ADJUST2
F4 F5 F6 F7 F8 F9 F10