Sony DVS-7300 System User Manual page 116

4
Adjust the parameter values.
When you have selected a luminance key, linear key, or clean key:
Knob Parameter
1 Clip
2 Gain
3 Density
4 Filter
When you have selected a chroma key:
Knob Parameter
3 Density
When you have selected a pattern key:
Knob Parameter
1 Size
2 Softness
3 Density
5
If necessary, make the following settings.
• When you have selected a luminance key, linear key, or clean key, to
adjust the width or horizontal position of the key source, press F6 (KEY
POS), turning it on, and set the parameters.
Knob Parameter
1 Left Pos
2 Right Pos
3 H Phase
• To invert the sense of the key source signal, press F8 (KEY INVERT),
turning it on.
• To reverse the priority of key 1 and key 2, press F9 (PRIORTY), to
interchange the OVER and UNDER indications.
OVER: Key 1 is over.
The KEY 1 OVER indicator in the transition control section lights.
UNDER: Key 1 is under.
The KEY 2 OVER indicator in the transition control section lights.
Setting
Set clip level on the key signal (–10.00 to +110.00)
Set key sharpness (0.00 to 100.00)
Set key density (0.00 to 100.00)
Select filter coefficient (1 to 5)
Setting
Set key density (0.00 to 100.00)
Setting
Set pattern size (0.00 to 100.00)
Set degree of edge softness (0.00 to 100.00)
Set key density (0.00 to 100.00)
Setting
Move the left edge of the key (–3.00 to +3.00)
Move the right edge of the key (–3.00 to +3.00)
Move the key
Chapter 4 Basic Operations for Image Creation
4-49