Sony DVS-7300 System User Manual page 208

To display the status for a single bank
Select one of items 1 to 3 (M/E-1 to M/E-3) to display the status of the
snapshot or wipe information stored in the FlexiPad for the bank. For
example, selecting item 1 displays the M/E-1 STATUS menu.
The status information displayed depends on which of F1 (SNAPSHOT) to
F3 (DME WIPE) is selected.
It is also possible to display these status screens by pressing the button in the
FlexiPad twice in rapid succession. For details, see page 4-143.
Selecting an auxiliary bus signal
To select an auxiliary bus signal in the ALL STATUS menu, use the
following procedure.
1
Press F8 (AUX SELECT).
The function key indications change as follows.
[AUX9] [AUX10] [AUX11]
AUX1 AUX2 AUX3
F1 F2 F3
Function key indications in the ALL STATUS menu (when F8 is selected)
2
Press the function key corresponding to the desired auxiliary bus.
To select AUX9 to ED PVW, press F1 to F6 while holding down the
SHIFT button in the menu control section.
3
Enter the button number corresponding to the desired signal from the
numeric keypad, or use the cursor movement buttons (> . ? /) to
align the cursor with the required signal display, then press F10
(SELECT).
Setting the transition rate
To set the transition rate in the ALL STATUS menu (see page 4-140), use
the following procedure.
1
Press F10 (TRANS RATE).
The function key indications change as follows. The indications for F5
to F10 depend on the selections of F1 to F4.
[AUX12] [AUX13] [ED PVW]
AUX4 AUX5 AUX7
AUX6
F4 F5 F6 F7
Chapter 4 Basic Operations for Image Creation
AUX8 SELECT
F8 F9 F10
(Continued)
4-141