Sony DVS-7300 System User Manual page 422

3
Carry out the operation in the following table to make the required
setting.
Setting
Setting the control
function for bus
control from an RS-
422A port
Setting the function
for recalling auxiliary
bus settings when
executing a key frame
or snapshot
Carrying out setup relating to interface settings for a digital
multi effects (DME INTERFACE menu)
You can use the DME INTERFACE menu for the following settings.
• Making the reentry cross-point button setting: Select the cross-point
button number for the required auxiliary bus output which is connected
to a DME and reinput to the switcher from a DME output.
• Setting the on-air tally function: Select the tally output mode to be
applied when a DME output is selected on the switcher.
SELF: When a DME output is selected on the switcher, a tally for the
signal used in the DME is output regardless of the DME state.
OFF: An on-air tally signal for the signals used by the DME is not
output from the SERIAL TALLY connector of the switcher.
By processing DME tally information output by the DME-7000 with a
BKDS-7700 Tally Interface Unit, you can obtain more accurate tally
information about the signals used by the DME.
• Making the auxiliary bus setting for output to DMEs: Select the required
auxiliary bus from AUX 1 to AUX 13 connected as video/key input to
DMEs.
• Assigning DMEs for DME wipes: Select the DMEs used for DME wipes
on an M/E bank and the PGM/PST (DSK) bank.
Operation
According to the switcher port for which you wish to make
the setting, press one of F2 (PANEL) to F9 (PANEL2).
• F2 toggles the setting between ENBL and DSBL.
• F3 to F9 cycle the setting through ENBL, DSBL and
MANUAL.
Press F10 (KF/SS).
This toggles the setting between ENBL and DSBL.
13-51
Chapter 13 Setup