Table of Contents
Advertisement
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
• Setting the programmable button function: You can assign functions to
13-74
Chapter 13 Setup
ON: When you press the shift button it lights, and locks, shifting the
cross-point button selection. To release the lock, press the shift
button once more.
When the signal selection in the bank changes with the progress of
the transition, the state of the shift button automatically changes so
that the cross-point button for the currently selected signal lights.
HOLD: The shift button locks as described above for the ON setting, but
the state of the shift button does not change with the progress of the
transition.
the programmable buttons on the control panel. The programmable
buttons and functions available for allocation are as follows.
Programmable button Functions available for allocation
KEY INV: The KEY
NO ASSIGN: No function allocated.
INV button in the key
KEY INVERT ON/OFF: Switches the key invert function
control section of
each M/E bank (see
MAIN MASK ON/OFF: Switches the main mask on or
page 2-16)
SUB MASK ON/OFF: Switches the subsidiary mask on
EDGE MATTE ON/OFF: Set this to ON to insert a signal
4H DROP ON/OFF: Toggle on and off the "4H DROP"
Note
These settings are common to all M/E banks. (It is not
possible to make independent settings for different
banks.)
NO ASSIGN: No function allocated. (Factory default
P/P NEXT
TRANSITION
BLANK: Unlabeled
NEXT TRANS ALL: When you press the button, as the
button to the right of
the DSK2 button
(above the WIPE
button) in the
transition control
section of the PGM/
PST bank (3.5-M/E
panel) (see page 2-
22)
on or off. (Factory default setting)
off.
or off.
from the dedicated matte generator as key edge fill.
When this is set to OFF, the signal selected on the
utility bus is used for edge fill. Press the button, turning
it on, then adjust matte 1 with knobs 1 to 3: Luminance
(0.00 to 100.00), Saturation (0.00 to 100.00), and Hue
(0.00 to 359.99).
mode for key fill and key source.
setting)
image for the next transition on the PGM/PST bank,
the background, and downstream keys 1, 2, 3, and 4
are simultaneously selected (the BKGD, and DSK1 to
DSK4 next transition buttons all light).
(Continued)
Advertisement
Table of Contents
