Sony DVS-7300 System User Manual page 394

Carrying out setup relating to switcher input signals
(SWITCHER INPUT menu) (in a D1 system)
You can use the SWITCHER INPUT menu for the following settings.
• Selecting 8- or 10-bit mode for a digital input signal
• Adjusting the horizontal phase of an input signal: Adjust the horizontal
phase of the input signal in the range –16 to +16 CK (clock cycles).
To carry out these settings, use the following procedure.
1
In the INPUT/OUTPUT menu, press F3 (SWER INPUT).
The SWITCHER INPUT menu appears.
BUTTON
No.
F1
For details of indications other than for the function keys in the
SWITCHER INPUT menu, see the next item "Indications in the
SWITCHER INPUT menu".
2
Select the cross-point button to which the settings apply, using either of
the following methods.
• Hold down F1 (BUTTON No.) and press the required cross-point
button in the auxiliary bus bank.
• Hold down F1 (BUTTON No.) and use the cursor movement keys to
select the required cross-point button.
• Hold down F1(BUTTON No.) and turn control knob 2.
• Hold down F1(BUTTON No.) and enter the required cross-point button
number using the numeric keypad.
PHASE
BITS
ADJUST
10
F2 F3 F4 F5
Function key indications in the SWITCHER INPUT menu
F6 F7 F8 F9
(Continued)
Chapter 13 Setup
F10
13-23