Table of Contents
Advertisement
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
• Setting custom modes: You can make the following custom settings for the
13-76
Chapter 13 Setup
operating mode of parts of the control panel.
a) Switching the operating mode of the FlexiPad: You can switch the
operating mode of the FlexiPad in each of the M/E banks.
MODE1: Factory default operating mode. For details see page 7-10.
MODE2: This changes the operation of snapshot recall as follows.
To specify register numbers 1 to 9
1 Press the SNAPSHOT button, which lights amber.
2 Press one of the numeric keys 1 to 9.
To specify register numbers 10 to 19
1 Press the SNAPSHOT button, which lights amber.
2 Press the SHIFT button, which lights amber.
3 Press one of the numeric keys 0 to 9; the SHIFT button goes off.
To specify register numbers 20 to 99
1 Press the SNAPSHOT button, which lights amber.
2 Hold down the SHIFT button, and press the 2 numeric key; the
SHIFT button lights green.
3 Press one of the numeric keys 0 to 9.
4 To subsequently specify another register in the range 20 to 29, with
the SHIFT button lit green, press one of the numeric keys 0 to 9
again.
In step 2, press 3 to 9 in place of 2 in order to specify a register in the
range 30 to 99.
To return to the state in which one of registers 1 to 19 can be
specified, press the SHIFT button lit green, turning it off.
Advertisement
Table of Contents
