Path Settings
3
4
5
8-22
Chapter 8 Key Frame Effects
SPLINE: Use a spline curve to provide a smooth interpolation.
The selected interpolation path type is shown on the menu display by an
icon.
In order not to switch the input signals, set F8 (XPT DSBL) to "ON".
Press F10 (HUE PATH).
The function key indications change as follows.
HUE
M/E1
M/E2
M/E3
CCW
CCW
CCW
F1
F2
F3
Press one of F1 (M/E1) to F5 (PGM/PST DSK) to select the HUE path
type for the corresponding bank.
Pressing each of F1 to F5 cycles through the following settings:
CW: The hue rotates clockwise as viewed on a Vectorscope.
CCW: The hue rotates counterclockwise as viewed on a Vectorscope.
LONG: The hue changes by the maximum amount. If there is no
difference of hue between two key frames, the hue rotates clockwise
through 360 degrees.
SHORT: The hue changes by the minimum amount.
The selected hue interpolation curve is shown on the menu display by an
icon.
PGM/PST
DSK
CCW
F4
F5
F6
F7
F8
F9
F10