Wipes
4-110
Chapter 4 Basic Operations for Image Creation
F4 (ANGLE): rotate the pattern.
Knob
Parameter
1
Angle
a) To avoid problems at the fader limits, depending on the angle, the pattern size is
automatically corrected.
F5 (SPEED): rotate the pattern at a constant angular speed.
Knob
Parameter
1
Speed
a) To avoid problems at the fader limits, the pattern size is automatically increased
compared with the case in which the pattern does not rotate.
F6 (MAG): specify angle through which pattern turns through the
course of the transition.
Knob
Parameter
1
Angle
2
Magnitude
a) To avoid problems at the fader limits, depending on the angle when the transition
completes, the pattern size is automatically corrected.
F7 (H MOD): modulate the pattern, giving a horizontal waviness to the
edge.
Knob
Parameter
1
Amplitude
2
Frequency
3
Speed
F8 (V MOD): modulate the pattern, giving a vertical waviness to the
edge.
Knob
Parameter
1
Amplitude
2
Frequency
3
Speed
Note
The F7 (H MOD) and F8 (V MOD) parameter settings are common to
the main and subsidiary patterns. Therefore, changing the settings for
one pattern automatically assigns the same values to the other pattern.
Setting
Rotation angle (–50.00 to +50.00) (maximum one
a)
whole turn)
Setting
Rotation speed (–50.00 to +50.00)
Setting
Pattern orientation when the transition starts (–50.00
to +50.00)
Rotation through transition (–100.00 to +100.00)
(maximum plus or minus two whole turns)
Setting
Set the modulation amplitude (0.00 to 100.00)
Set the modulation frequency (0.00 to 100.00)
Set the modulation speed (–50.00 to +50.00)
Setting
Set the modulation amplitude (0.00 to 100.00)
Set the modulation frequency (0.00 to 100.00)
Set the modulation speed (–50.00 to +50.00)
a)
a)