Sony DVS-7300 System User Manual page 186

F3 (OFF): do not apply any of the rotation modifiers (ANGLE, SPEED,
or MAGNITUDE).
F4 (ANGLE): rotate the pattern.
Knob
1
a) To avoid problems at the fader limits, depending on the angle, the pattern size is
automatically corrected.
F5 (SPEED): rotate the pattern at a constant angular speed.
Knob
1
a) To avoid problems at the fader limits, the pattern size is automatically increased
compared with the case in which the pattern does not rotate.
F6 (MAG): specify angle through which pattern turns through the
course of the transition.
Knob
1
2
a) To avoid problems at the fader limits, depending on the angle when the transition
completes, the pattern size is automatically corrected.
Resetting all of the wipe modifiers to the default settings
It is possible to reset all of the wipe modifiers for the currently selected wipe
pattern to the default settings.
You can determine the default settings using a setup menu operation.
For more information about the default settings, see the section on the
BACKUP menu (page 13-13).
For the PGM/PST bank:
In the menu control section, hold down the P/P WIPE top menu button in the
SYSTEM group for about 2 or 3 seconds.
For the downstream keyer:
In the menu control section, hold down the DSK WIPE top menu button in
the SYSTEM group for about 2 or 3 seconds.
Parameter Setting
Angle Rotation angle (–50.00 to +50.00) (maximum one
whole turn)
Parameter Setting
Speed Rotation speed (–50.00 to +50.00)
Parameter Setting
Angle Pattern orientation when the transition starts (–50.00
to +50.00)
Magnitude Rotation through transition (–100.00 to +100.00)
(maximum plus or minus two whole turns)
Chapter 4 Basic Operations for Image Creation
a)
a)
a)
4-119