Table of Contents
Advertisement
Mix/Effects Banks
3 Next transition selection buttons
These buttons determine what the next
transition will apply to.
BKGD: Next transition is a background
transition.
KEY 1: Next transition will insert or
remove key 1. If key 1 is currently
inserted it will be removed, and vice
versa.
KEY 2: Next transition will insert or
remove key 2. If key 2 is currently
inserted it will be removed, and vice
versa.
KEY PRIOR (priority): Next transition
will interchange the priority
relationship between key 1 and key 2.
More than one of these four buttons can be
lit simultaneously.
4 Transition type selection buttons
Press one of these buttons, turning it on, to
determine the type of the next transition.
MIX: In a background transition, the new
video (bus B) fades in as the old video
(bus A) fades out. The new video
level is increased from 0% to 100% as
the old video is reduced from 100% to
0%, in such a way that the overall
signal level is always 100%.
In a key transition, the key fades in
(for insertion) or out (for removal).
NAM (non-additive mix): The old
background and new background
video signals are compared, and the
higher one is used as the output.
The old video is reduced from 100%
to 0% over the second half of the
transition, and the new video level is
increased from 0% to 100% over the
first half, all the while combining the
two signals by non-additive mixing.
2-12
Chapter 2 Location and Function of Parts
SUPER MIX: The old video is reduced
from 100% to 0% over the second half
of the transition, and the new video
level is increased from 0% to 100%
over the first half, all the while
combining the two signals by
(ordinary) mixing.
It is also possible to set the video
levels at the mid-point of the transition
to any value between 0 and 100%, by
using the BKGD/TRANS menu for
the M/E bank.
WIPE: The transition executed will be a
wipe, using the settings in the wipe
setting menu for the M/E bank.
DME 1: The transition will be a wipe-like
effect, using the effects provided by
DME channel 1. This requires at least
one DME-7000 or other Digital Multi
Effects unit to be connected to the
switcher system.
To carry out a dual DME wipe using
the effects provided by two DME
channels, press this button and the
DME 2 button simultaneously, turning
them on.
You can use a setup operation to make
this button select DME 3 or DME 5
instead.
DME 2: The transition will be a wipe-like
effect, using the effects provided by
DME channel 2. This requires at least
two DME-7000 or other DME units to
be connected to the switcher system.
To carry out a dual DME wipe using
the effects provided by two DME
channels, press this button and the
DME 1 button simultaneously, turning
them on.
You can use a setup operation to make
this button select DME 4 or DME 6
instead.
Advertisement
Table of Contents
