Table of Contents
Advertisement
Snapshot Operations
You can use the numeric keypad section or the FlexiPad in one of the M/E
banks for saving and recalling snapshots.
Using the numeric keypad section you can carry out all snapshot operations
except applying (or removing) the "KEY DISABLE" attribute.
Using the FlexiPad in an M/E bank, you can carry out snapshot operations for
this particular M/E bank.
Snapshot Operations Using the Numeric Keypad
Section
This section describes how to carry out snapshot operations using the
numeric keypad section.
Saving a snapshot
To save a snapshot using the numeric keypad section, use the following
procedure.
Note
If you specify the number of a register which already holds a snapshot, then
the saving operation overwrites the previous snapshot. Before specifying the
number of the register in which you wish to save the snapshot, check that the
register is empty, or contains a snapshot which is no longer needed. You can
check the contents of registers using the REGISTER menu (see page 9-3).
1
2
7-6
Chapter 7 Snapshots
Set up the switcher in the state you wish to save in the snapshot.
In the numeric keypad section, press the SNAPSHOT button.
This delegates the numeric keypad section to snapshot operations.
Advertisement
Table of Contents
