Table of Contents
Advertisement
Fading a key in or out on an M/E bank using the KEY MIX button
Press the corresponding KEY MIX button in the key control section. This
begins the transition at the preset rate.
During the fade in or fade out, when the key is inserted in the output from the
M/E bank, the KEY ON button lights amber, and if it is present in the final
program output, the KEY ON button lights red.
Inverting the priority of keys 1 and 2 on an M/E bank
If for example key 1 is over key 2 (the key 1 OVER indicator in the transition
control section is lit), to instantaneously invert the relation between the two
keys, press the KEY PRIOR button in the transition control section, then
press the CUT button. The key 1 OVER indicator goes out, and the key 2
OVER indicator lights.
Note that you can also invert the key priority with a menu operation. (See
page 4-49.)
Executing a manual transition with the fader lever
To carry out a manual transition, you can control the progress of the
transition directly, using the fader lever as follows.
• To execute a complete transition, move the lever from one end of its range
to the other.
• To pause the transition, simply stop moving the lever.
• To resume the transition, start moving the lever again.
Combining auto and manual transition control
You can use either of the following techniques to combine manual and auto
transition control.
Using the fader lever during an auto transition
After starting an auto transition by pressing the AUTO TRANS button, if you
move the fader lever to the position corresponding to the current transition
state, the auto transition control is released, the AUTO TRANS button goes
off, and from now on the fader lever controls the transition.
Chapter 4 Basic Operations for Image Creation
4-35
Advertisement
Table of Contents
