Table of Contents
Advertisement
Wipes
5
6
7
Selecting a wipe pattern using the numeric keypad
To select a pattern by number using the numeric keypad, use the following
procedure.
To check pattern numbers, consult the Appendix "Wipe Patterns" (page A-2).
1
2
4-102
Chapter 4 Basic Operations for Image Creation
Press F1 (MIX) once again, turning it on.
The main and subsidiary patterns are now combined, and function key
indications for F5 to F7 now appear.
Press one of F5 to F7, to make the main and subsidiary modifier link
function setting.
F5 (OFF): Do not use the link function.
F6 (SEMI): Use the link function in "SEMI LINK" mode
F7 (FULL): Use the link function in "FULL LINK" mode
Note
When carrying out a wipe transition, press F7 (FULL).
If necessary, adjust the "Mix" parameter.
Knob
Parameter
1
Mix
When you have selected diamond dust (pattern 274):
In this case you can adjust the twinkling rate.
Knob
Parameter
4
Flash Rate
In the PATTERN menu, select F2 (MAIN) or F3 (SUB).
Enter the number of the required pattern, using the numeric keypad, then
press the ENTER button.
The newly selected pattern now appears on the screen in the "MAIN" or
"SUB" area.
Setting
Degree of combination of the two patterns (0.00 to
100.00)
Setting
Twinkling rate of diamond dust (0.00 to 100.00)
Advertisement
Table of Contents
