Table of Contents
Advertisement
3
Press F2 (PORT SELECT) or turn control knob 2 to move the cursor and
select the required GPI input port of the device selected in step 2.
4
Press F3 (TRIGGER TYPE), and select the trigger polarity.
Pressing F3 cycles the setting through
If you selected LEVEL in this step or DMK in step 2, continue to step 6.
5
Press F4 (SELECT) to move the cursor and select the operating bank of
the selected device on which the GPI input trigger action is to be carried
out.
To apply the same action to all selectable banks
Press F5 (ALL).
6
Press F9 (ACTION SELECT) or turn control knob 3 to move the cursor
and select the action to be carried out when the trigger occurs.
To delete a selected action
Select "NO USE" with the cursor.
7
Press F7 (SELECT) to confirm the action selection.
When you have selected any of SS RECALL?, EFF RECALL?, and
RECALL?&RUN?
Further specify register numbers using the numeric keypad and press the
ENTER button.
8
To trigger actions on more than one operating bank from the GPI input
from the same GPI input port, repeat steps 5 to 7 for each bank.
9
To trigger actions from the GPI input from a different GPI input port on
the same device, repeat steps 3 to 8 for each GPI input port.
,
,
, NOP, and LEVEL.
Chapter 13 Setup
13-59
Advertisement
Table of Contents
