Sony DVS-7300 System User Manual page 456

10
Press F3 (AUTOSEL SETUP).
The AUTO SEL SETUP menu appears.
AUTOSEL
SELECT TYPE
#2 SWER
F1 F2 F3
Function key indications in the AUTOSEL SETUP menu
11
Press F2 (AUTOSEL SELECT), or turn control konb 2 to align the
cursor with the auto select table you wish to select.
12
Press F3 (TYPE) to select whether the cross-point auto select function
applies to the internal bus (the DVS-7000 switcher bus) or only to the
external bus (the bus of the routing switcher connected to the DVS-
7000).
SWER: The auto select function applies only to the internal bus.
ROUTER: The auto select function applies only to the external bus.
13
Press F6 (1) to F10 (5).
The AUTOSEL TABLE SETUP (1/2/3/4/5) menu appears.
The method of using this menu is the same as that of the AUTO
SELECT ASSIGN menu. See the section "Allocating a key source signal
to a key fill" (page 13-72).
Linking a button to a GPI output port
After carrying out steps 1 to 4 of the procedure in the previous section,
"Linking operations on two buses", continue with the following steps.
5
Press F9 (MASTER/LINK) to set F9 to "MASTER".
The indication for F10 changes to "MASTER SELECT".
AUTOSEL TABLE SETUP
1 2
F4 F5 F6 F7
3 4 5
F8 F9 F10
(Continued)
13-85
Chapter 13 Setup