Sony DVS-7300 System User Manual page 457

Setup Relating to Operations From the Control Panel
(OPERATION Menu)
6
7
8
9
10
11
12
13-86
Chapter 13 Setup
Press F10 (MASTER SELECT) or turn control knob 3 to align the cursor
with the button you wish to select as the master button (the button
causing the GPI output), then press F8 (SELECT).
This selects the button with which the cursor is aligned as the "master
button".
Press F9 (MASTER/LINK) to set F9 to "LINK".
The indication for F10 changes to "LINK SELECT".
Press F10 (LINK SELECT) or turn control knob 3 to align the cursor
with the GPI port (1 to 8) you wish to link to the "master button" selected
in step 5, then press F8 (SELECT).
This confirms the selection of the GPI port with which the cursor is
aligned.
To set the time delay (0 to 300 fields) between the output of the GPI
trigger and the execution of the function allocated to the "master button",
press F6 (DELAY) and turn knob 4 to set the value.
Press F4 (ENABLE BUS).
The ENABLE BUS menu appears.
REGION
PST
SELECT PGM K1 BUS
#2
F1 F2 F3
Function key indications in the ENEBLE BUS menu (when M/E-1/2/3 is selected)
Press F1 (REGION SELECT) or turn control knob 2 to align the cursor
with the bank (M/E-1, M/E-2, etc.) you wish to select.
The function key indications for F2 and subsequent keys change to show
the bus names, according to the bank with which the cursor is aligned.
Press the function keys corresponding to the buses, making the keys be
displayed in reverse video to enable the link to the GPI output port, or
making them be displayed in normal video to disable the link.
K2 BUS UTIL
F4 F5 F6 F7 F8 F9 F10