Basic Path Setting Operations - Sony DVS-7300 System User Manual

4
Press one of F1 (ALL) to F6 (PGM/PST DSK), to select the sub-register
to which the settings apply.
For example, selecting F2 (M/E-1) allows you to make path settings
separately for the items (KEY 1, KEY 2, WIPE, etc.) on the M/E-1 bank.
To make path settings for the whole M/E-1 bank without separating
items, press F1 (ALL).
Depending on the sub-register selection, different function key
indications appear. For further details, read the following sections.

Basic Path Setting Operations

ALL settings
Setting the path for all banks
Use the following procedure.
1
In the SWER KF PATH menu, press F1 (ALL).
The function key indications change as follows.
M/E1
LINEAR
F1
2
Press one of F1 (M/E1) to F5 (PGM/PST DSK) to select the curve path
type for the corresponding bank.
Pressing each of F1 to F5 cycles through the following settings:
OFF: Make no change as the effect proceeds.
STEP: Change stepwise at each key frame. In other words, there is no
interpolation in the interval between key frames.
LINEAR: Interpolate linearly between key frames. This maintains a
constant speed of movement.
S-CURVE: Accelerate and decelerate around each key frame, so that
the speed is maximum at the mid-point between two key frames.
CURVE
PGM/PST
M/E2 M/E3 USER DSK
LINEAR LINEAR LINEAR LINEAR
F2 F3 F4 F5
XPT
DSBL
OFF
F6 F7 F8 F9
(Continued)
Chapter 8 Key Frame Effects
HUE
PATH
F10
8-21