Table of Contents
Advertisement
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
Assigning registers to the SHOT BOX buttons (SHOT BOX
menu)
You can assign switcher or DME registers storing such data as snapshots and
key frame effects to the 14 UTILITY button or the 32 buttons on BKDS-
7033 Memory Recall Control Panel Unit. Pressing one of the buttons to
which such a register has been assigned then recalls the snapshot or key
frame effect stored in the register assigned to the button (shot box function).
To use the BKDS-7033 as the SHOT BOX, it is necessary to assign the shot
box function to the buttons of the BKDS-7033 using the UTILITY menu.
(See page 13-90.)
The shot box function can also be realized by connecting the optional BKDS-
8061 Memory Recall Remote Panel Unit to the switcher control panel,
instead of using the optional BKDS-7033. Up to two BKDS-8061 units can
be connected to the switcher control panel. When two BKDS-8061 units are
connected to the switcher control panel, you can assign up to 40 registers to
their buttons.
To connect the BKDS-8061 to a control panel, the BKDS-7001 Control Panel
Option
Expansion Board is required.
Note
When both the BKDS-7033 and the BKDS-8061 are used, the registers
assigned to the buttons of either of the two panels are also assigned to the
correspondindg buttons on the other panel. You cannot assign different
registers to the buttons same-numbered on the two panels.
13-92
Chapter 13 Setup
Advertisement
Table of Contents
