Sony DVS-7300 System User Manual page 415

Setup Relating to Keyers, Wipes and Other Effects (EFFECT Menu)
Carrying out setup relating to wipes (WIPE menu)
You can use the WIPE menu for the following settings.
• Adjusting the wipe pattern center position: For the three types of wipe
• Adjusting the softness of the wipe edge: For the above three types of
To carry out these settings, use the following procedure.
1
2
13-44
Chapter 13 Setup
listed below, you can adjust the center position of the wipe pattern
horizontally and vertically in the range –15.0 to +15.0 pixels.
M/E wipes
PGM/PST wipes (3.5-M/E systems only)
Downstream key wipes (3.5-M/E systems and 3-M/E systems equipped
with a downstream keyer only)
wipe, you can adjust the softness of the wipe edge in the range –50.00 to
+50.00%.
In the EFFECT menu, press F4 (WIPE).
The WIPE menu appears.
M/E
CENTER EDGE
ADJUST SOFT
F1 F2 F3
Function key indications in the WIPE menu
Carry out the operation in the following table to make the required
setting.
Setting
Adjusting an M/E wipe
pattern center position
Adjusting a PGM/PST or
downstream keyer wipe
pattern center position
Adjusting the softness
of an M/E wipe edge
Adjusting the softness of a
PGM/PST or downstream
keyer wipe edge
P/P DSK
CENTER EDGE
ADJUST SOFT
F4 F5 F6 F7
Operation
Press F2 (CENTER ADJUST), turning it to reverse
video, and adjust the horizontal position with control
knob 3 and the vertical position with control knob 4.
Press F5 (CENTER ADJUST), turning it to reverse
video, and adjust the horizontal position with control
knob 3 and the vertical position with control knob 4.
Press F3 (EDGE SOFT), turning it to reverse video,
and adjust with control knob 4.
Press F6 (EDGE SOFT), turning it to reverse video,
and adjust with control knob 4.
F8 F9 F10