Sony DVS-7300 System User Manual page 156

4
Adjust the parameters until the selected image is in the desired position.
Knob Parameter
1 H Move
2 V Move
Note
In a D2 system when you have selected F2 (LIVE), an operation to move
the image horizontally may in some cases result in a vertical movement.
5
If you selected F2 (LIVE) in step 2, press F5 (INPUT MASK) to select
whether or not to mask the input image.
OFF: Move the entire image.
ON: Move only the part of the image defined by a mask, using either a
rectangular box or the dedicated pattern generator. In this case, select the
mask source and set the parameters accordingly.
For details of the settings, see steps 9 to 12 of the procedure in the
section "Creating a new key fill and key source and writing them to
memory" (page 4-86).
To return a moved image to the center position
In the DSK MEMORY menu with F10 (MOVE) selected, press F4 (POS
CENTER).
Write-protecting the frame – LOCK
In the FILL/SOURCE menu (page 4-84), press F9 (MEMORY LOCK),
turning it on.
Setting
Horizontal position (–50.00 to +50.00)
Vertical position (–50.00 to +50.00)
Chapter 4 Basic Operations for Image Creation
4-89