Sony DVS-7300 System User Manual page 409

Setup Relating to Input/Output Signals (INPUT/OUTPUT Menu)
• Auto preview function: When you press the NEXT TRANSITION button
• Auto preview 2 function: With this function the EDIT PVW bus operates
13-38
Chapter 13 Setup
in the transition control section of an M/E bank, the preview signal for
that M/E bank is output from the CLEAN OUT connector of the DVS-
7000.
At this point the NEXT TRANSITION button lights green, to indicate
that the preview for the M/E bank is being output.
as follows.
In a 3.5-M/E system, with the final preview output of the DMK-7000
connected to the DIRECT IN input of the DVS-7000, when you select
the M/E1 PVW, M/E2 PVW, M/E3 PVW, or PRESET signal on the
EDIT PVW bus, then depending on the signal which is on air, the
output signal from the EDIT PVW bus is switched as shown in the
following table.
Signal selected on the
EDIT PVW bus
M/E1 PVW M/E1 on air
M/E2 PVW
M/E3 PVW
PRESET
Condition
Not on air
M/E2 on air
Not on air
M/E3 on air
Not on air
When the same M/E is
selected on the PGM and
PST buses
Other cases
Output signal from the
EDIT PVW bus
M/E1 PVW
M/E1 PGM
M/E2 PVW
M/E2 PGM
M/E3 PVW
M/E3 PGM
M/E1 PVW, M/E2 PVW,
M/E3 PVW
PGM/PST PVW