Table of Contents
Advertisement
Bus
Background A
Background B
Key 1 and key 2 fill
Key 1 and key 2
source
Program (BKDS-
7023)
Preset (BKDS-7023)
AUX 1 to AUX 13
Edit preview
Frame memories 1
and 2
M/E-1, M/E-2, and M/
E-3 utility buses
Assigning signals to cross-point button columns
Each row of cross-point buttons in the M/E banks, PGM/PST bank (3.5-M/E
systems only), and auxiliary bus bank includes 29 basic buttons for signal
assignment. It is also possible to assign a shift function to one button,
allowing a maximum total of 56 assignable signals. Using a setup menu
operation, you can assign any of the columns in either the unshifted or shifted
state to any of the signals from the PRIMARY INPUTS 1 to 36 connectors
on the switcher unit, or to various signals generated internally by the
switcher.
For the procedure for assignment, see page 13-68.
Although in principle the signal assignment is to a column of buttons, there
are cases in which a particular signal cannot be selected on a particular bus.
For details of the restrictions on selecting certain signals, see page 13-68.
Cross-point buttons and buses for the BKDS-7011/7023
Button row Banks
A
M/E-1, M/E-2, M/E-3
B
K
M/E-1, M/E-2, M/E-3
K
M/E-1, M/E-2, M/E-3
Auxiliary bus cross-point buttons
PGM
PGM/PST
PST
Auxiliary bus cross-point buttons
Chapter 4 Basic Operations for Image Creation
Delegation operation
None required.
Press the KEY 1 or
KEY 2 button in the
corresponding key
control section, turning
it on.
Press the KEY 1 or
KEY 2 button in the key
control section of the
relevant M/E bank to
delegate the
corresponding keyer,
then hold down the
SPLIT button.
None required.
Press the required
auxiliary delegation
button, turning it on.
4-7
Advertisement
Table of Contents
