Sony DVS-7300 System User Manual page 43

Auxiliary Bus Bank
3 Delegation buttons
Press one of these buttons, turning it on, to
delegate the cross-point buttons to the
corresponding bus.
AUX 1 to AUX 13 buttons: These
correspond to auxiliary buses 1 to 13.
The signals on these buses are output
from the connectors on the rear panel
labeled AUX BUS OUTPUTS 1 to 13.
EDIT PVW (preview) button: This
corresponds to the edit preview bus.
The signal on this bus is output from
the connector on the rear panel labeled
EDIT PVW OUTPUT.
FRAME MEM (memory) 1 and 2
buttons: These correspond to frame
memory buses 1 and 2. The signals
selected on these bases are input to
frame memory 1 and 2.
M/E1 to M/E3 UTIL buttons: These
correspond to the utility buses on the
M/E banks.
2-28
Chapter 2 Location and Function of Parts
4 Selected signal display
This displays the identifier of the source
signal currently selected on each bus.
5 SHIFT button
Hold down this button and press a cross-
point button to select one of the signals
numbered 30 to 58. At this time the
identifiers assigned to the shifted buttons
are displayed.
6 Programmable button
By means of a SETUP menu setting, you
can use this button for switching the
auxiliary bus bank between controlling the
auxiliary buses and controlling a routing
switcher.
For details, see the section "Changing
switcher functions (OPERATION MODE
menu)" (page 13-73).