Combining two wipe patterns in a pattern mix
Carrying out a pattern mix requires the optional BKDS-2070 Enhanced Wipe
Option
Generator Board to be installed.
To combine the main pattern with the subsidiary pattern in a pattern mix, use
the following procedure.
1
In the PATTERN menu, press F3 (SUB), turning it on.
You can now select the subsidiary pattern.
MIX
F1
2
Press F5 (1) or F6 (2), turning it on, to display page 1 or page 2 of the
wipe pattern display.
3
Use the cursor keys (> . ? /) to select the required pattern, then
press F10 (ENTER).
Depending on the main pattern selection, some subsidiary pattern
selections are not possible.
For details of the admissible combinations of patterns, see the table on
page 4-93.
The pattern you have selected appears on the screen in the "SUB" area.
4
Press F1 (MIX).
The function key indications change as follows.
MIX
OFF
F1
PATTERN
MAIN
SUB
F2
F3
F4
Function key indications in the PATTERN menu (after pressing F3)
PATTERN
MAIN
SUB
F2
F3
F4
Function key indications in the PATTERN menu (after pressing F1)
Chapter 4 Basic Operations for Image Creation
PAGE
1
2
F5
F6
F7
F8
MAIN/SUB LINK
SEMI
FULL
OFF
F5
F6
F7
F8
ENTER
F9
F10
F9
F10
(Continued)
4-101