Danfoss VLT AQUA Drive FC 202 Programming Manual page 39

Parameter Description
0-72 Time Format
Option: Function:
Sets the time format to be used in the LCP.
[0] 24 h
[1] 12 h
0-74 DST/Summertime
Option: Function:
Select how daylight saving time/summertime should
be handled. For manual DST/summertime enter the
start date and end date in parameter 0-76 DST/
Summertime Start and parameter 0-77 DST/
Summertime End.
[0] Off
[2] Manual
0-76 DST/Summertime Start
Range: Function:
Size related [ 0 - 0 ] Sets the date and time when DST/
*
summertime starts. The date is
programmed in the format selected in
0-71 Date Format.
0-77 DST/Summertime End
Range: Function:
Size related [ 0 - 0 ] Sets the date and time when DST/
*
summertime ends. The date is
programmed in the format selected in
0-71 Date Format.
0-79 Clock Fault
Option: Function:
Enables or disables the clock warning, when the
clock has not been set or has been reset due to a
power-down and no back-up is installed. If MCB
109 is installed, [1] Enabled is default.
[0] Disabled
[1] Enabled
0-81 Working Days
Array with 7 elements [0] - [6] displayed below parameter
number in display. Press [OK] and step between elements with
▲ ▼
[ ] and [ ].
Option: Function:
Set for each weekday if it is a working day or a non-
working day. First element of the array is Monday. The
working days are used for timed actions.
[0] No
[1] Yes
MG20O702
Programming Guide
0-82 Additional Working Days
Array with 5 elements [0] - [4] displayed below parameter
number in display. Press [OK] and step between elements with
▲
[ ] and [
Range:
Size related
0-83 Additional Non-Working Days
Array with 15 elements [0] - [14] displayed below parameter
number in display. Press [OK] and step between elements with
▲
[ ] and [
Range:
Size related
0-89 Date and Time Readout
Range:
0 [0 - 25 ] Displays the current date and time. The date and
*
Danfoss A/S © Rev. 2014-01-21 All rights reserved.
▼
].
Function:
[ 0 - 0 ] Defines dates for additional working days
*
that normally would be non-working
days according to
parameter 0-81 Working Days.
▼
].
Function:
[ 0 - 0 ] Defines dates for additional working days
*
that normally would be non-working
days according to
parameter 0-81 Working Days.
Function:
time is updated continuously.
The clock does not begin counting until a setting
different from default has been made in 0-70 Date
and Time.
3 3
37